Aruba 2930M 48G PoE+ 1-slot Switch (JL322A)
Aruba 2930M 48G PoE+ 1-slot Switch (JL322A)
| SPECIFICATIONS | |
| Aruba 2930M 48G PoE+ 1-slot Switch (JL322A) | |
| I/O ports and slots | |
| 44 Autosensing 10/100/1000
ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASETX, IEEE 802.3ab Type 1000Base-T, IEEE 802.3at PoE+); Duplex: 10BASE‑T/100BASE-TX:half or full;1000BASE-T:full only 4 Combo 10/100/1000BASE-T PoE+ or 100/1000Mbps SFP Ports |
|
| Additional ports and slots | |
| 1 Dual Personality (RJ-45 or USB
Micro-B) serial console port 1 USB A port for uploading/ downloading files 1 100BASE-T Out of Band Management Port 1 Uplink Slot 1 Stacking Module Slot 2 Power Supply Slots (power supplies not included) |
|
| Physical characteristics | |
| Dimensions | 1.73" (Height) x 17.42" (Width) x
12.77" (Depth) (4.39cm x 44.25cm x 32.43cm) |
| Weight | 10.25 lbs 4.65 kg |
| Memory and processor | |
| Dual Core ARM Cortex A9 @ 1016
MHz, 1 GB DDR3 SDRAM; Packet buffer size: 12.38 MB 4.5 MB Ingress/7.785 Egress, 4 GB eMMC |
|
| Performance | |
| 10 Mbps Latency |
< 98.5µs (FIFO 64 byte packets) |
| 100 Mbps Latency | < 11.8µs (FIFO 64-byte Packets) |
| 1,000 Mb Latency |
< 3.4µs (FIFO 64-byte packets) |
| 2.5 Gbps Latency | N/A |
| 5 Gbps Latency | N/A |
| 10 Gbps Latency | < 2.9 μs (64-byte packets) |
| Throughput | up to 112 Mpps |
| Stacking Performance |
100 Gbps |
| Switching capacity | 176 Gbps |
| Switching Capacity (Including Stacking) |
276 Gbps |
| Routing table size | 2,000 IPv4, 1,000 IPv6 in hardware, 200 OSPF, 256 Static, 10,000 RIP |
| MAC address table size | 32,768 entries |
| Environment | |
| Operating temperature | 32°F to 131°F (0°C to 55°C) up to
5000ft, 32°F to 122°F (0°C to 50°C). Derate -1 degree C for every 1000 ft from 5000 ft to 10000 ft |
| Operating relative humidity | 15% to 95% (Non-condensing) 10,000 ft |
| Non operating/Storage temperature |
-40°C to +70°Cup to 15000 ft |
| Non-operating/Storage relative humidity |
90% at 65C (non-condensing); 15,000 ft |
| Acoustic | Sound Power LWaD=4.6 Bel, Sound Pressure LpAm, Bystander = 28.9 dB |
| Primary Airflow Direction |
Port to Power |
| Electrical characteristics | |
| Frequency | 50/60 Hz |
| Power efficiency certifications |
|
| Maximum heat dissipation | 355 BTU/hr 375 kJ/hr |
| Voltage | JL086A PSU:
100-127/200-240 VAC JL087A PSU: 110-127/200-240 VAC |
| Current | JL086A PSU (each): 5A/2.5A
JL087A PSU (each): 9A/4.5A |
| Maximum power rating | JL086A PSU (each): 470W
JL087A PSU (each): 860W |
| Idle power | 73W |
| PoE power | 1440 Watts |
| Notes | Idle power is the actual power consumption of the device with no ports connected. Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. |
| Safety | |
| UL 60950-1: 2nd Edition; UL 62368-1: 2nd Edition; EN 60950-1:2006 +A11:2009 +A1:2010 +A12:2011+A2:2013; EN 62368-1: 2nd Edition; IEC 60950- 1:2005 +A1:2009 +A2:2013; CSA 22.2 No. 60950-1-07 2nd; IEC-62368-1:2nd Edition; EN 60825-1:2014 / IEC 60825-1:2014 Class 1 |
|
| Emissions | |
| EN 55032:2012/CISPR 32 Class A; FCC CFR 47 Part 15 Class A; VCCI Class A; ICES-003 Class A; CNS 13438 |
|
| Immunity | |
| Generic | EN 55024:2010/CISPR 24 |
| ESD | IEC 61000-4-2 |
| Radiated | IEC 61000-4-3 |
| EFT/Burst | IEC 61000-4-4 |
| Surge | IEC 61000-4-5 |
| Conducted | IEC 61000-4-6 |
| Power frequency magnetic field |
IEC 61000-4-8 |
| Voltage dips and Interruptions |
IEC 61000-4-11 |
| Harmonics | IEC/EN 61000-3-2 |
| Flicker | IEC/EN 61000-3-3 |
| Management | |
| Aruba Central; Aruba AirWave Network Management; IMC – Intelligent Management Center; Command-line interface; Web browser; Configuration menu; SNMP manager; Telnet; RMON1; FTP |
|
